1. In the process of hardware parts processing, employees must check whether their clothes meet the work requirements before entering their posts and preparing for parts processing. In addition, slippers, high-heeled shoes and clothes that affect safety are not allowed to wear during the processing of hardware parts, and those with long hair should wear safety helmets. In addition, it is necessary to maintain correct posture and have enough spirit to cope with the work when working on metalworking. If you find that you are unwell, you should leave the job immediately and report to the leader immediately. During operation, the operator must concentrate on each other, and no chatting is allowed. The operator must not operate in a fretful and tired state to avoid accidents and ensure operation safety.
2. Before the metalworking machine works, check whether the moving part is filled with lubricating oil, then start and check whether the clutch and brake are normal, and run the machine without load for 1-3 minutes. It is strictly prohibited to operate the machine in case of mechanical failure.
3. When replacing the die, first turn off the power, and then start to install and debug the die after the punch movement department stops running. After installation and adjustment, move the flywheel by hand to test punch twice, and check whether the upper and lower molds are symmetrical and reasonable, whether the screws are firm, and whether the blank holder is in a reasonable position.
4. Only after all other personnel leave the mechanical working area and take away the sundries on the workbench can the power supply be started to start the machine for safe processing.
5. After the metalworking machine is started, one person shall transport materials and operate the machine. Other people shall not press the electric building or step on the foot switch board, nor put their hands into the mechanical work area or touch the moving part of the machine with their hands. During the mechanical work of metalworking, it is prohibited to stretch your hand into the slider working area, and it is prohibited to take and place the workpiece by hand. Tools that meet the standards must be used when taking and placing workpieces in the die. In case of any abnormal sound or malfunction of the machine, the power switch shall be turned off immediately for inspection.
6. When off duty, the idle power supply shall be turned off, and the finished products, leftovers and sundries on the post shall be sorted out to ensure a clean and safe working environment.
Asset Metal technology company is a focusing on metalworking, for example, CNC machining, metal stamping, chemical etching and surface treatment of OEM/ODM metal parts Processing.
+8613538580966
